 |
 |
 |
|
Preformed Line Products FIBERLIGN® Dielectric Dead-end Kit for ADSS 2872109C1E1 .835" - .889" Dead-end component is required to transfer axial tensile loads and distribute radial compressive forces through the plastic jacket and onto the internal strength members without damaging the fragile plastic jacket or internal optical fibers.
ADSS Dead End Kits ADSS Dead Ends ADSS Self Support
- Limited Tension Dead-ends are intended for use with
- these conditions and limitations:
- Low tensions, approximately: - 1,000# (4.4kN) maximum initial
- (stringing/nominal axial/long-term) tension - 2,500# (11.1 kN) maximum loaded
- (working/loaded axial/short-term) tension
- Short spans: - 300' - 600' (91-183 m) typical maximum spans
- depending upon cable OD and tensions - not recommended for critical crossing
- spans (highways, rivers, etc.); see Medium or High Tension Dead-ends
- Low strength cables
- “Standard” jackets
- Most cable brands
- No excessive operating conditions, cable motion or high
- temperatures.
|
|
|
 |
|
 |
|
