Used to support CATV and telephone cables from the strand. The end of the strap is tapered to provide easy installation into...

The Spiral Vibration Damper is a motion control product used to dissipate aeolian vibration that may occur on cable spans. Using the recommended number of Spiral Vibration Dampers minimizes bending strain, protecting the cable from long-term fatigue due to aeolian vibration.
Used on Bare Conductors, Shield Wires and OPGW
Cable Diameter Range (mm): .327-.461
Length inches (m):51 (1.30)

The Spiral Vibration Damper is a motion control product used to dissipate aeolian vibration that may occur on cable spans. Using the recommended number of Spiral Vibration Dampers minimizes bending strain, protecting the cable from long-term fatigue due to aeolian vibration.

Used on Bare Conductors, Shield Wires and OPGW
Spiral Vibration Damper OPGW .462-.563
Length inches 51"

The Spiral Vibration Damper is a motion control product used to dissipate aeolian vibration that may occur on cable spans. Using the recommended number of Spiral Vibration Dampers minimizes bending strain, protecting the cable from long-term fatigue due to aeolian vibration.

Used on Bare Conductors, Shield Wires and OPGW
Spiral Vibration Damper OPGW .564-.760
USED WITH OPGW 0.75".

The FIBERLIGN Dielectric Damper is a motion control product used to dissipate aeolian vibration that may occur on ADSS cable spans. Using the recommended number of dielectric dampers minimizes aeolian vibration and increases cable longevity.

Cable Diameter Range
0.327 – 0.461
Length
8.3

The FIBERLIGN Dielectric Damper is a motion control product used to dissipate aeolian vibration that may occur on ADSS cable spans. Using the recommended number of dielectric dampers minimizes aeolian vibration and increases cable longevity.

Cable Diameter Range
0.250 – 0.326
Length
49"

The FIBERLIGN Dielectric Damper is a motion control product used to dissipate aeolian vibration that may occur on ADSS cable spans. Using the recommended number of dielectric dampers minimizes aeolian vibration and increases cable longevity.

Cable Diameter Range
0.771 – 0.876
Length
19.6

The FIBERLIGN Dielectric Damper is a motion control product used to dissipate aeolian vibration that may occur on ADSS cable spans. Using the recommended number of dielectric dampers minimizes aeolian vibration and increases cable longevity.

Cable Diameter Range
0.877 – 1.000
Length
22.3"

The FIBERLIGN Dielectric Damper is a motion control product used to dissipate aeolian vibration that may occur on ADSS cable spans. Using the recommended number of dielectric dampers minimizes aeolian vibration and increases cable longevity.

Cable Diameter Range
0.564 – 0.770
Length
65

The ADSS-CORONA Coil is intended to reduce electrical stress at the ends of the metal rods of FIBERLIGN® Dielectric Dead-Ends and Suspensions installed in high-voltage environments (areas where electrical lines are 115 kV and higher or areas where an electrical field analysis places the space potential of the ADSS cable above 12 kV).

The ADSS-CORONA Coil is intended to reduce electrical stress at the ends of the metal rods of FIBERLIGN® Dielectric Dead-Ends and Suspensions installed in high-voltage environments (areas where electrical lines are 115 kV and higher or areas where an electrical field analysis places the space potential of the ADSS cable above 12 kV).
PLP 50603745 CORONA COIL ADSS .742-.844, PLP 50603760 CORONA COIL ADSS .688-.741