Adsco Stainless Steel Lashing Wire Clamp LWC-304SS
Stainless Steel Adsco Lashing Wire Clamp
Scope:
This item standard is intended for use in conjunction with CSA standard CAN/CSA-C83. This item is normally mounted on messenger strand and is used to terminate cable lashing wire.
Assembly:
The lashing wire clamp is comprised of two clamp sections, two flat washers, and two hex nut assemblies on a shouldered stud. The stud should key into one clamp section at assembly to prevent stud rotation as the nuts are tightened. This keying feature is constructed to allow proper closing of the jaws. Both ends of the stud should be suitably modified after assembly to prevent loss of the nuts.
Accommodation:
The clamp will accommodate a range of messenger strand from 3/16″ to 9’16” diameter designated strand size
Adsco 5/8" Stainless Steel Single Bolt Suspension Clamp SBSC-1
Stainless Steel Single Bolt Suspension Clamp SBSC-1
- Used to attach strand to straight line poles.
- Accepts 1/4" to 7/16" strand.
- Consist of two hot rolled, specially-shaped plates.
- Plates are 1-11/16" wide and 2-1/2" long.
- Center hole accepts 5/8" Thru Bolts
Adsco 3/4" Stainles Steel Guy Hook GH34
Stainless Steel Adsco Heavy Duty Guy Hook GH34
- Designed to accept a loop of strand, a strand grip, or a Strand Dead-end in down guy applications.
- Features a wide inner shoulder and broad heel pad to resist embedding
- Cannot be used in “back to back” guying on pole.
- Mounting Bolts 3/4"
Adsco 5/8" Stainless Steel Guy Hook GH58
Stainless Steel Adsco Heavy Duty Guy Hook GH58
- Designed to accept a loop of strand, a strand grip, or a Strand Dead-end in down guy applications.
- Features a wide inner shoulder and broad heel pad to resist embedding
- Cannot be used in “back to back” guying on pole.
- Mounting Bolts 5/8"
Adsco 3/4" Stainless Steel Heavy Duty Guy Hook GH2
Stainless Steel Adsco Heavy Duty Guy Hook GH2
- Two Spurs to Resist Pole Splitting
- More Surface in Contact with Pole than other Comparable Guy Attachments – Greater Protection to Wood Fibers
- For Round or Flat Surfaces
- Will intercept Wire at any Angle
- Mounting Bolts TOP- 1" - 7/8", BOTTOM- 3/4" - 5/8", AND/OR 1/2" L.S.
